uCNC Error 1
uCNCErrorPosition is kept
The controller got a line that isn't proper G-code: something without a letter, or a stray character.
Position is kept. An error means the controller refused that one line or command, so nothing moved for it. (Hamrun's reading)
What to do
- Open the file and look at the line it stopped on for stray characters, comments without brackets, or text from another program.
- Check the post-processor matches your controller.
Name in the uCNC source:
STATUS_EXPECTED_COMMAND_LETTER. The meaning above is in Hamrun's words; uCNC's own message text isn't copied here. sourceGot a different message?
Paste it into the decoder. Hamrun's editor checks your G-code before you run it, so a toolpath that leaves the machine's travel or a missing feed rate is caught before the machine stops. Have the whole file? Check it here, free: it finds the line that triggers this, and the file never leaves your computer.
Related codes
- GRBL 1.1 Error 1: The controller got a line that isn't proper G-code: something without a letter, or a stray character.
- grblHAL Error 1: The controller got a line that isn't proper G-code: something without a letter, or a stray character.
- FluidNC Error 1: The controller got a line that isn't proper G-code: something without a letter, or a stray character.
- Grbl_Esp32 Error 1: The controller got a line that isn't proper G-code: something without a letter, or a stray character.
Code name taken from the uCNC source on 2026-11-10; the meaning is in Hamrun's words and uCNC's message text isn't copied. Steps and the position answer are Hamrun's reading unless marked “firmware says”. User reports are labelled CLAIMED.