uCNC Alarm 11

uCNCAlarmPosition isn't set yet: home first

A limit switch reads as pressed, so the controller won't move until it's clear.

Position isn't set yet: home first. Hamrun's reading: the controller won't trust position with a switch active. (Hamrun's reading)
What to do
  1. Jog the machine off the switch (homing is usually the only move allowed).
  2. If nothing is touching it, check the switch wiring and the inverted setting ($5).
What users reported CLAIMED · forum and issue reports, not official
Name in the uCNC source: EXEC_ALARM_HOMING_FAIL_LIMIT_ACTIVE. The meaning above is in Hamrun's words; uCNC's own message text isn't copied here. source

Got a different message?

Paste it into the decoder. Hamrun's editor checks your G-code before you run it, so a toolpath that leaves the machine's travel or a missing feed rate is caught before the machine stops. Have the whole file? Check it here, free: it finds the line that triggers this, and the file never leaves your computer.

Related codes

  • grblHAL Alarm 12: A limit switch reads as pressed, so the controller won't move until it's clear.

Code name taken from the uCNC source on 2026-11-10; the meaning is in Hamrun's words and uCNC's message text isn't copied. Steps and the position answer are Hamrun's reading unless marked “firmware says”. User reports are labelled CLAIMED.