Grbl_Esp32 Error 20
Grbl_Esp32ErrorPosition is kept
The line has a G or M code this controller doesn't know.
Position is kept. An error means the controller refused that one line or command, so nothing moved for it. (Hamrun's reading)
What to do
- Find the code on the line it stopped on (for example G41, M6 or G28.1 on some boards).
- Use the post-processor for your controller, or remove that command.
Name in the Grbl_Esp32 source:
GcodeUnsupportedCommand. The meaning above is in Hamrun's words; Grbl_Esp32's own message text isn't copied here. sourceGot a different message?
Paste it into the decoder. Hamrun's editor checks your G-code before you run it, so a toolpath that leaves the machine's travel or a missing feed rate is caught before the machine stops. Have the whole file? Check it here, free: it finds the line that triggers this, and the file never leaves your computer.
Related codes
- GRBL 1.1 Error 20: The line has a G or M code this controller doesn't know.
- grblHAL Error 20: The line has a G or M code this controller doesn't know.
- FluidNC Error 20: The line has a G or M code this controller doesn't know.
- uCNC Error 20: The line has a G or M code this controller doesn't know.
Code name taken from the Grbl_Esp32 source on 2026-11-10; the meaning is in Hamrun's words and Grbl_Esp32's message text isn't copied. Steps and the position answer are Hamrun's reading unless marked “firmware says”. User reports are labelled CLAIMED.