Grbl_Esp32 Alarm 5

Grbl_Esp32AlarmPosition is kept

The probe moved its full distance and never touched the plate.

Position is kept. The probe move ended normally; it just didn't find contact. (Hamrun's reading)
What to do
  1. Check the plate is under the bit and the clip is on the bit (or the collet).
  2. Start the probe closer to the plate, or give it a longer probing distance.
  3. Touch the clip to the plate by hand and see whether the probe light changes. If it doesn't, check the probe wiring.
Name in the Grbl_Esp32 source: ProbeFailContact. The meaning above is in Hamrun's words; Grbl_Esp32's own message text isn't copied here. source

Got a different message?

Paste it into the decoder. Hamrun's editor checks your G-code before you run it, so a toolpath that leaves the machine's travel or a missing feed rate is caught before the machine stops. Have the whole file? Check it here, free: it finds the line that triggers this, and the file never leaves your computer.

Related codes

  • GRBL 1.1 Alarm 5: The probe moved its full distance and never touched the plate.
  • grblHAL Alarm 5: The probe moved its full distance and never touched the plate.
  • FluidNC Alarm 5: The probe moved its full distance and never touched the plate.
  • uCNC Alarm 5: The probe moved its full distance and never touched the plate.

Code name taken from the Grbl_Esp32 source on 2026-11-10; the meaning is in Hamrun's words and Grbl_Esp32's message text isn't copied. Steps and the position answer are Hamrun's reading unless marked “firmware says”. User reports are labelled CLAIMED.