Grbl_Esp32 Alarm 10

Grbl_Esp32AlarmNot a position problem

The spindle controller reported a problem.

Not a position problem. Hamrun's reading: FluidNC doesn't say. If it stopped mid-cut, home before trusting position. (Hamrun's reading)
What to do
  1. Check the spindle or VFD is powered and its cable is connected.
  2. Check the spindle section of your FluidNC config file.
Name in the Grbl_Esp32 source: SpindleControl. The meaning above is in Hamrun's words; Grbl_Esp32's own message text isn't copied here. source

Got a different message?

Paste it into the decoder. Hamrun's editor checks your G-code before you run it, so a toolpath that leaves the machine's travel or a missing feed rate is caught before the machine stops. Have the whole file? Check it here, free: it finds the line that triggers this, and the file never leaves your computer.

Related codes

Code name taken from the Grbl_Esp32 source on 2026-11-10; the meaning is in Hamrun's words and Grbl_Esp32's message text isn't copied. Steps and the position answer are Hamrun's reading unless marked “firmware says”. User reports are labelled CLAIMED.